Viscoelastic properties of nanostructured natural rubber/polystyrene interpenetrating polymer networks

The effects of the blend ratio and initiating system on the viscoelastic properties of nanostructured natural rubber/polystyrene‐based interpenetrating polymer networks (IPNs) were investigated in the temperature range of ?80 to 150 °C. The studies were carried out at different frequencies (100, 50, 10, 1, and 0.1 Hz), and their effects on the damping and storage and loss moduli were analyzed. In all cases, tan δ and the storage and loss moduli showed two distinct transitions corresponding to natural rubber and polystyrene phases, which indicated that the system was not miscible on the molecular level. However, a slight inward shift was observed in the IPNs, with respect to the glass‐transition temperatures (T_g's) of the virgin polymers, showing a certain degree of miscibility or intermixing between the two phases. When the frequency increased from 0.1 to 100 Hz, the T_g values showed a positive shift in all cases. In a comparison of the three initiating systems (dicumyl peroxide, benzoyl peroxide, and azobisisobutyronitrile), the dicumyl peroxide system showed the highest modulus. The morphology of the IPNs was analyzed with transmission electron microscopy. The micrographs indicated that the system was nanostructured. An attempt was made to relate the viscoelastic behavior to the morphology of the IPNs. Various models, such as the series, parallel, Halpin–Tsai, Kerner, Coran, Takayanagi, and Davies models, were used to model the viscoelastic data. The area under the linear loss modulus curve was larger than that obtained by group contribution analysis; this showed that the damping was influenced by the phase morphology, dual‐phase continuity, and crosslinking of the phases. Finally, the homogeneity of the system was further evaluated with Cole–Cole analysis. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1680–1696, 2003     

玻璃的冲击损伤

冲蚀过程是一个与颗粒反复冲击物体表面而移除物质相关的表面现象．本文研究了玻璃的冲蚀坑的几何尺寸和体积，给出了冲蚀移除物质如何依赖于颗粒流动速度、颗粒尺寸和冲击角的理论关系．通过理论与实验结果相比较，定义了一定冲蚀坑尺度的有效域．     

含铒碲酸盐玻璃的上转换荧光性质研究

在室温下,用804nm波长的半导体激光器作激发源,在TeO_2-PbO基掺铒碲酸盐玻璃中实现了中心波长分别为525nm,550nm和660nm的上转换发射.荧光强度与激发功率呈非线性关系.估测了PbO含量对上转换荧光相对强度的影响.     

Formation of lead pyrophosphate glass and the role of anion disproportionation

Thermal, spectroscopic and electrical properties of lead pyrophosphate glass prepared by melt quenching have been examined. A model based on the structural disproportionation of the P₂O ₇ ⁴⁻ ions has been proposed and is shown to consistently explain all the observations. The equilibrium of various anionic species has been discussed on the basis of their electronegativities which are in turn related to their basicities. Communication No. 129 from the Materials Research Centre     

激光标线的原理和实验

根据几何光学知识分析了激光标线原理.理论和实验表明:激光标线长度与激光光束形状、光学元件形状及材料折射率有关.并讨论了激光标线向两侧扩展的原因.     

1.54μmEr3+,Yb3+共掺玻璃激光器的速率方程及数值分析

LD抽运共掺Er,Yb玻璃激光器中的跃迁过程较复杂,针对双掺离子之间的能量传递和Er3+的多种跃迁过程,给出了详细的准三能级系统的速率方程,在合理简化后进行了数值分析,分析了Er3+掺杂浓度和介质长度、抽运光斑、输出镜透过率、谐振腔长、抽运光的椭圆度等因素对激光阈值及斜率效率的影响. 关键词： 1.54μm激光 Er3+玻璃 速率方程 数值分析     

非晶钛酸铋的晶化过程

利用差热分析、X射线衍射和透射电子显微镜等技术对溶胶-凝胶法合成的凝胶的晶化过程进行了分析，实验结果表明，Bi₄Ti₃O₁₂非晶凝胶晶化过程经历了四个过程：首先在433℃先形成了Bi₂O₃和TiO₂亚稳相，然后在488℃时TiO₂亚稳相与Bi₂O₃反应形成Bi，Ti复合氧化物亚稳相Bi₂T 关键词： 钛酸铋 铁电材料 溶胶凝胶 非晶 晶化过程     

Fe对掺钕磷酸盐激光玻璃激光性能的影响

 在理论分析的基础上，具体讨论了Fe质量分数小于10^-4对1 053 nm处光吸收损耗和Nd³⁺无辐射跃迁几率的影响规律，发现Fe在1 053 nm处的光吸收损耗和Nd³⁺无辐射跃迁能量转移都与Fe质量分数成平方关系增长， Fe对1 053 nm光吸收的影响较大而Fe与Nd³⁺之间的能量转移不足50 Hz。这对生产过程中Fe含量的控制有重要指导意义。     

Upconversion luminescence of Tm^3＋/Yb^3＋ codoped oxyfluoride glasses

Novel oxyfluoride glasses are developed with the composition of 30SiO2-15Al2O3-28PbF2-22CdF2-0.1TmF3 - xYbF3 - （4.9 - x） AlF3（x=0, 0.5, 1.0, 1.5, 2.0） in tool fraction, Furthermore, the upconversion luminescence characteristics under a 970nm excitation are investigated. Intense blue, red and near infrared luminescences peaked at 453nm, 476nm, 647nm and 789nm, which correspond to the transitions of Tm^3＋： ^1D2 →^3F4, ^1G4 →^3H6, ^1G4 →^3F4, and ^3H4 →^3H6, respectively, are observed. Due to the sensitization of Yb^3＋ ions, all the upconversion luminescence intensities are enhanced considerably with Yb^3＋ concentration increasing. The upconversion mechanisms are discussed based on the energy matching rule and quadratic dependence on excitation power. The results indicate that the dominant mechanism is the excited state absorption for those upconversion emissions.     

Eu3+掺杂硼酸盐玻璃的光谱性质研究

测试了不同浓度掺杂下Eu^3＋离子在硼酸盐玻璃的吸收光谱、激发光谱与发射光谱，根据荧光光谱计算了各样品的强度参数力2与／24，分析了Eu^3＋离子掺杂浓度对其发光强度的影响．研究结果表明：在Eu^3＋离子高掺杂浓度时，会发生浓度猝灭效应，但由于Eu^3＋激活离子之间能量传递几率很小，使得Eu^3＋离子猝灭浓度较高。